DTC    B1472/72    A/C Inverter High Voltage Output System Malfunction

for Preparation Click here


DESCRIPTION

The inverter in the compressor with motor assembly outputs high-voltage to operate the motor. If there is an open or short in the output circuit, the ECU will stop compressor operation and store the DTC. The DTC will be stored as a history DTC. The compressor operation remains stopped until both the history and current DTCs are cleared.

DTC No.
DTC Detection Condition
Trouble Area
B1472/72
Open or short in A/C inverter high voltage output system.
  1. Compressor with motor assembly
  2. CAN communication system

INSPECTION PROCEDURE

CAUTION:
  1. Wear electrically insulated gloves and pull out the service plug grip before inspection as procedures may require disconnecting high-voltage connectors. Be sure to carry the removed service plug grip because other workers may install it by mistake.
  2. Do not touch the high-voltage connectors or terminals for 10 minutes after the service plug grip is removed.

NOTICE:
  1. After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).
  2. The hybrid control system and air conditioning system output DTCs separately. Inspect DTCs following the flow chart for the hybrid control system first if any DTCs from those systems are output simultaneously.

1.CHECK CAN COMMUNICATION SYSTEM

  1. Using the intelligent tester to check if the CAN communication system is functioning normally.

    Result:
    Result
    		Proceed to
    CAN DTC is not output
    		A
    CAN DTC is output
    		B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A

REPLACE COMPRESSOR WITH MOTOR ASSEMBLY (Click here)