SLIDING ROOF SWITCH ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT SLIDING ROOF SWITCH (MAP LIGHT ASSEMBLY)


    B260665E01

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    		Switch Condition
    		Specified Condition
    25 (DOWN) - 3 (GND3)
    		TILT DOWN switch is pressed
    		Below 1 Ω
    25 (DOWN) - 3 (GND3)
    		TILT DOWN switch is not pressed
    		10 kΩ or higher
    24 (UP) - 3 (GND3)
    		TILT UP switch is pressed
    		Below 1 Ω
    24 (UP) - 3 (GND3)
    		TILT UP switch is not pressed
    		10 kΩ or higher
    28 (CLS) - 3 (GND3)
    		SLIDE CLOSE switch is pressed
    		Below 1 Ω
    28 (CLS) - 3 (GND3)
    		SLIDE CLOSE switch is not pressed
    		10 kΩ or higher
    27 (OPN) - 3 (GND3)
    		SLIDE OPEN switch is pressed
    		Below 1 Ω
    27 (OPN) - 3 (GND3)
    		SLIDE OPEN switch is not pressed
    		10 kΩ or higher

    Text in Illustration 
    *a
    		Component without harness connected
    (Sliding Roof Switch (Map Light Assembly))
    If the result is not as specified, replace the sliding roof switch (map light assembly).