FRONT SEAT ASSEMBLY (for Power Seat) > INSTALLATION

for Preparation Click here

1. Place the front seat assembly in the cabin.
   

   NOTICE:

   Be careful not to damage the vehicle body.

2. Connect the connectors under the seat.
   

3. Connect the cable to the negative (-) battery terminal.
   

   NOTICE:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

4. Temporarily install the front seat assembly with the 4 bolts.
   

5. Operate the power seat switch knob and move the seat to the rearmost position.
   

6. Tighten the 2 bolts on the front side of the seat.
   

   Torque:

   37 N*m{ 375 kgf*cm , 27 ft.*lbf }

   NOTICE:

   Tighten the bolts in the order indicated in the illustration.

7. Operate the power seat switch knob and move the seat to the foremost position.
   

8. Tighten the 2 bolts on the rear side of the seat.
   

   Torque:

   37 N*m{ 375 kgf*cm , 27 ft.*lbf }

   NOTICE:

   Tighten the bolts in the order indicated in the illustration.

1. Engage the 2 claws to install the rear inner seat track bracket cover.
   

1. Engage the 2 claws to install the rear outer seat track bracket cover.
   

1. Operate the power seat switch knob and move the seat to the rearmost position.
   

2. Engage the 2 claws to install the front inner seat track bracket cover.
   

1. Engage the 2 claws to install the front outer seat track bracket cover.
   

1. Check the power seat operation (Click here).
   

2. w/ Seat Heater System:
   Check the seat heater operation.
   
   

   1. Turn the power switch on.
      

   2. Turn the seat heater switch on.
      

   3. Wait 5 minutes or more and confirm that the seat surface becomes warm.
      

1. Engage the 4 claws and 2 guides to install the rear floor board upper No. 3 plate.
   

1. Engage the 6 guides.
   

2. Install the deck floor box RH with the clip.
   

1. Install the rear No. 3 floor board.
   

1. Install the rear deck floor box.
   

1. Install the rear No. 2 floor board.