WIRELESS DOOR LOCK CONTROL SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. The wireless door lock control system troubleshooting procedure is based on the premise that the power door lock control system is operating normally. Check the power door lock control system first before troubleshooting the wireless door lock control system. Use this procedure to troubleshoot the wireless door lock control system.
  2. *: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS

      HINT:
      1. In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
      2. Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.
      3. The following 5 items are important points in the problem analysis:

      What
      		Vehicle model, system name
      When
      		Date, time, occurrence frequency
      Where
      		Road conditions
      Under what conditions?
      		Running conditions, driving conditions, weather conditions
      How did it happen?
      		Problem symptoms


    NEXT


    3.INSPECT AUXILIARY BATTERY VOLTAGE

    1. Measure the auxiliary battery voltage with the power switch off.

      Standard Voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.


    NEXT


    4.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*

    1. Use the intelligent tester to check if the CAN communication system is functioning normally.

      Result:
      Result
      		Proceed to
      DTC is not output
      		A
      DTC is output
      		B



    		B.
    GO TO CAN COMMUNICATION SYSTEM (Click here)
    A


    5.CHECK DTC OUTPUT (WIRELESS DOOR LOCK CONTROL SYSTEM)

    1. Clear the DTCs (Click here).

    2. Recheck for DTCs.

      Result:
      Result
      		Proceed to
      DTC is not output
      		A
      DTC is output
      		B



    		B.
    GO TO DIAGNOSTIC TROUBLE CODE CHART (Click here)
    A


    6.PROBLEM SYMPTOMS TABLE

    1. Refer to Problem Symptoms Table (Click here).

      Result:
      Result
      		Proceed to
      Fault is not listed in Problem Symptoms Table.
      		A
      Fault is listed in Problem Symptoms Table.
      		B



    		B.
    Go to step 8
    A


    7.OVERALL ANALYSIS AND TROUBLESHOOTING*

    1. Operation Check (Click here)

    2. Terminals of ECU (Click here)

    3. Data List / Active Test (Click here)


    NEXT


    8.REPAIR OR REPLACE

      NEXT


      9.CONFIRMATION TEST

        NEXT

        END