BRAKE PEDAL STROKE SENSOR (for LHD) > REMOVAL

for Preparation Click here


NOTICE:
While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch is turned on. Therefore, when servicing brake system components, do not depress the brake pedal or open/close the doors while the auxiliary battery is connected.



1. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
(Click here)


2. REMOVE BRAKE PEDAL STROKE SENSOR ASSEMBLY


    C233733

  1. Disconnect the connector from the brake pedal stroke sensor assembly.



    C233734

  1. Remove the 2 nuts and brake pedal stroke sensor assembly from the brake pedal support assembly.

    NOTICE:
    1. Do not drop the brake pedal stroke sensor assembly.
    2. If the brake pedal stroke sensor assembly has been dropped, replace the brake pedal stroke sensor assembly with a new one.