REAR SEAT INNER BELT ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT REAR SEAT INNER BELT ASSEMBLY (for RH)


    B273021E01

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    		Condition
    		Specified Condition
    1 - 2
    		Rear RH seat belt fastened
    		Below 1 Ω
    1 - 2
    		Rear RH seat belt not fastened
    		10 kΩ or higher

    Text in Illustration 
    *a
    		Component without harness connected
    (Rear Seat Inner Belt Assembly (for RH))
    If the result is not as specified, replace the rear seat inner belt assembly (for RH).



2. INSPECT REAR SEAT INNER W/ CENTER BELT ASSEMBLY LH (for LH)


    B273022E01

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    		Condition
    		Specified Condition
    1 - 2
    		Rear LH seat belt fastened
    		Below 1 Ω
    1 - 2
    		Rear LH seat belt not fastened
    		10 kΩ or higher

    Text in Illustration 
    *a
    		Component without harness connected
    (Rear Seat Inner w/ Center Belt Assembly LH (for LH))
    If the result is not as specified, replace the rear seat inner w/ center belt assembly LH (for LH).



3. INSPECT REAR SEAT INNER W/ CENTER BELT ASSEMBLY LH (for Center)


    B230306E05

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    		Condition
    		Specified Condition
    1 - 2
    		Rear center seat belt fastened
    		Below 1 Ω
    1 - 2
    		Rear center seat belt not fastened
    		10 kΩ or higher

    Text in Illustration 
    *a
    		Component without harness connected
    (Rear Seat Inner w/ Center Belt Assembly LH (for Center))
    If the result is not as specified, replace the rear seat inner w/ center belt assembly LH (for center).