FRONT SEAT INNER BELT ASSEMBLY (for Power Seat) > INSPECTION

for Preparation Click here



1. INSPECT FRONT SEAT INNER BELT ASSEMBLY (for Driver)


    B271232E02

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for LHD 
    Tester Connection
    		Condition
    		Specified Condition
    X15-1 - X15-2
    		Driver seat belt fastened
    		Below 1 Ω
    X15-1 - X15-2
    		Driver seat belt unfastened
    		10 kΩ or higher
    for RHD 
    Tester Connection
    		Condition
    		Specified Condition
    W9-1 - W9-2
    		Driver seat belt fastened
    		Below 1 Ω
    W9-1 - W9-2
    		Driver seat belt unfastened
    		10 kΩ or higher

    Text in Illustration 
    *A
    		for LHD
    *B
    		for RHD
    *a
    		Component without harness connected
    (Front Seat Inner Belt Assembly (for Driver))
    If the result is not as specified, replace the front seat inner belt assembly (for driver).