METER / GAUGE SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
*: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS

      NEXT


      3.CHECK CAN COMMUNICATION SYSTEM*

      1. Check for DTC output (Click here).

        Result:
        Result
        		Proceed to
        CAN DTC is not output
        		A
        CAN DTC is output
        		B



      		B.
      GO TO CAN COMMUNICATION SYSTEM (Click here)
      A


      4.PROBLEM SYMPTOM CONFIRMATION

        NEXT


        5.SYMPTOM SIMULATION

          NEXT


          6.PROBLEM SYMPTOMS TABLE

          1. Refer to Problem Symptoms Table (Click here).


          NEXT


          7.CIRCUIT INSPECTION

            NEXT


            8.REPAIR OR REPLACE

              NEXT


              9.CONFIRMATION TEST

                NEXT

                END