METER / GAUGE SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Warm up the engine.

  2. Turn the power switch off.

  3. Connect the intelligent tester to the DLC3.

  4. Turn the power switch on (IG).

  5. Turn the intelligent tester on.

  6. Enter the following menus:

    1. for Combination Meter: Body / Combination Meter / Data List.

    2. for ABS/VSC/TRC: Chassis / ABS/VSC/TRC / Data List.

    3. for Engine and ECT: Power Train / Engine and ECT / Data List.

    4. for Hybrid Control: Power Train / Hybrid Control / Data List.

    5. for Main Body: Body / Main Body / Data List.

  7. Check the values by referring to the table below.

    Combination Meter 
    Tester Display
    		Measurement Item/Range
    		Normal Condition
    		Diagnostic Note
    Tail Relay SW
    		Tail relay switch/OFF or ON
    		OFF: Tail relay switch off
    		-
    ON: Tail relay switch on
    ODO/TRIP Change SW
    		ODO/TRIP change switch knob/OFF or ON
    		OFF: Switch released
    		-
    ON: Switch pushed
    		-
    Tail Cancel SW
    		Tail cancel switch/OFF or ON
    		OFF: Tail cancel switch off
    		-
    ON: Tail cancel switch on
    P-Seatbelt Buckle SW
    		Front passenger side seat belt buckle switch/OFF or ON
    		OFF: Front passenger side seat belt unfastened
    		-
    ON: Front passenger side seat belt fastened
    Vehicle Speed Meter
    		Vehicle speed/Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph)
    		Almost the same as actual vehicle speed
    		-
    Engine Rpm
    		Engine speed/Min.: 0 rpm, Max.: 12750 rpm
    		600 to 700 rpm (When idling)
    		-
    Coolant Temperature
    		Engine coolant temperature/-40 to 127.5°C (-40 to 261.5°F)
    		After warming up: 75 to 100°C (167 to 212°F)
    		-
    Washer Switch
    		Washer fluid level warning switch/OFF or ON
    		OFF: Washer fluid level not low
    		-
    ON: Washer fluid level low
    		-
    Fuel Input
    		Fuel input/Min.: 0, Max. 127.5
    		Fuel sender gauge indicates F: 39.6
    		Unit: Liter
    Fuel sender gauge indicates 3/4: 31.0
    Fuel sender gauge indicates 1/2: 22.8
    Fuel sender gauge indicates 1/4: 14.3
    Fuel sender gauge indicates E: 5.1
    HV System Indicator
    		HV system indicator value/Min.: - 512, Max.: 511 (%)
    		-512 to 511 (%)
    		-
    Check Engine SW
    		MIL (Check engine warning light) on request signal/OFF or ON
    		OFF: MIL (Check engine warning light) off
    		-
    ON: MIL (Check engine warning light) on
    Multi Display Select Switch
    		DISP switch in the multi-information switch (steering pad switch assembly)/OFF or ON
    		OFF: DISP switch in the multi-information switch (steering pad switch assembly) not pressed
    		-
    ON: DISP switch in the multi-information switch (steering pad switch assembly) pressed
    +B Voltage Value
    		Auxiliary battery voltage/Min.: 0 V, Max.: 25.5 V
    		11 to 14 V
    		-
    Rheostat value
    		Light control rheostat value/Min.: 0 (dark), Max.: 255 (bright)
    		The light control rheostat value 0 (dark)
    		-
    The light control rheostat value 255 (bright)
    		-
    Ambient Temperature
    		Outside temperature/Min.: -40°C (-40°F), Max.: 87.5°C (189.5°F)
    		Almost the same as actual outside temperature
    		The temperature displayed on the multi-information display is -40 to 50°C (-40 to 122°F)
    2nd-Row Seatbelt Buckle (R)*1 or *2
    		Rear seat belt buckle switch RH/ OFF or ON
    		OFF: Rear seat belt RH unfastened
    		-
    ON: Rear seat belt RH fastened
    2nd-Row Seatbelt Buckle (L)*1 or *2
    		Rear seat belt buckle switch LH/ OFF or ON
    		OFF: Rear seat belt LH unfastened
    		-
    ON: Rear seat belt LH fastened
    2nd-Row Seatbelt Buckle (C)*1 or *2
    		Rear seat belt buckle switch center/OFF or ON
    		OFF: Rear seat belt center unfastened
    		-
    ON: Rear seat belt center fastened
    Oil Pressure Switch
    		Oil pressure switch/OFF or ON
    		OFF: Engine oil pressure low
    		-
    ON: Engine oil pressure not low
    Driver Side Seatbelt Warning Buzzer
    		The condition of the seat belt warning buzzer/OFF or ON
    		OFF: The seat belt warning buzzer does not sound at the vehicle speed of 20 km/h (12 mph) or more when the driver side seat belt unfastened
    		Displays customize setting of seat belt warning buzzer
    ON: The seat belt warning buzzer sounds at the vehicle speed of 20 km/h (12 mph) or more when the driver side seat belt unfastened
    P-Seatbelt Warning Buzzer
    		The condition of the seat belt warning buzzer/OFF or ON
    		OFF: The seat belt warning buzzer does not sound at the vehicle speed of 20 km/h (12 mph) or more when the front passenger side seat belt unfastened
    		Displays customize setting of seat belt warning buzzer
    ON: The seat belt warning buzzer sounds at the vehicle speed of 20 km/h (12 mph) or more when the front passenger side seat belt unfastened
    Rear Seatbelt Warning Buzzer*1
    		The condition of the rear seat belt warning buzzer/OFF or ON
    		OFF: The rear seat belt warning buzzer does not sound at the vehicle speed of 20 km/h (12 mph) or more when the rear seat belt unfastened
    		Displays customize setting of rear seat belt warning buzzer
    ON: The rear seat belt warning buzzer sounds at the vehicle speed of 20 km/h (12 mph) or more when the rear seat belt unfastened
    Reverse Buzzer
    		The customized setting of the reverse warning buzzer/Continual or Single
    		Continual: When the shift reverse (R) selected, buzzer sounds continuously
    		Displays customize setting of reverse warning buzzer
    Single: When the shift reverse (R) selected, a single buzzer sounds
    Number of Trouble Code
    		The number of the DTC which is currently output
    		0
    		-

    1. *1: w/ Rear Seat Belt Warning
    2. *2: w/ Seat Heater

    ABS/VSC/TRC 
    Tester Display
    		Measurement Item/Range
    		Normal Condition
    		Diagnostic Note
    FR Wheel Speed
    		Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
    		Vehicle stopped: 0 km/h (0 mph)
    		-
    FL Wheel Speed
    		Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
    		Vehicle stopped: 0 km/h (0 mph)
    		-
    RR Wheel Speed
    		Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
    		Vehicle stopped: 0 km/h (0 mph)
    		-
    RL Wheel Speed
    		Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
    		Vehicle stopped: 0 km/h (0 mph)
    		-
    Vehicle Speed
    		Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
    		Vehicle stopped: 0 km/h (0 mph)
    		-

    Engine and ECT 
    Tester Display
    		Measurement Item/Range
    		Normal Condition
    		Diagnostic Note
    Coolant Temp
    		Engine coolant temperature/Min.: -40°C (-40°F), Max: 140°C (284°F)
    		75 to 100°C (167 to 212°F): After warming up
    1. After warming up the engine: the engine coolant temperature 75 to 100°C (167 to 212°F).
    2. If the value is -40°C (-40°F) or 140°C (284°F), the sensor circuit open or shorted.

    Hybrid Control 
    Tester Display
    		Measurement Item/Range
    		Normal Condition
    		Diagnostic Note
    Engine Revolution
    		Engine speed/ Min.: 0 rpm, Max.: 16383.75 rpm
    1. While idling after the engine warmed up and inspection mode: approximately 900 rpm
    2. While driving at a constant speed: no significant fluctuation
    		-

    NOTICE:
    Enter the inspection mode (Click here).


    Main Body 
    Tester Display
    		Measurement Item/Range
    		Normal Condition
    		Diagnostic Note
    Illumination Rate Info
    		Illumination rate information/0 ms to 2162.65 ms
    		Value output according to ambient light levels
    		-


ACTIVE TEST
Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / Combination Meter / Active Test.

  5. Check the operation by referring to the table below.

    Combination Meter 
    Tester Display
    		Test Part
    		Control Range
    		Diagnostic Note
    Speed Meter Operation
    		Speedometer
    		0, 40, 80, 120 mph*1
    		-
    0, 40, 80, 120, 160, 200, 240 km/h*2
    Tacho Meter Operation
    		Tachometer
    		0, 1000, 2000, 3000, 4000, 5000, 6000, 7000 (rpm)
    		-
    Fuel Meter Operation
    		Fuel receiver gauge
    		EMPTY, 1/2, FULL
    		-
    A/T Indicator Operation 1
    		Shift indicator light (D, P, N. R, 4, 3, 2, L)
    		OFF or ON
    		-
    A/T Indicator Operation 2
    		Shift indicator light (S, 6, 5)
    		OFF or ON
    		-
    Indicat. Lamp Airbag
    		SRS warning light
    		OFF or ON
    		-
    Indicat. Lamp Doors All Open
    		Door indicator light
    		OFF or ON
    		-
    Driver Side Seat Belt
    		Seat belt warning light
    		OFF or ON
    		-
    Indicat. Lamp ABS
    		ABS warning light
    		OFF or ON
    		-
    Indicat. Lamp Charge
    		Charge warning light
    		OFF or ON
    		-
    Indicat. Lamp Slip
    		Slip indicator light
    		OFF or ON
    		-
    Indicat. Lamp Coolant Hot
    		Water temperature warning light
    		OFF or ON
    		-
    Indicat. Lamp Beam
    		High beam indicator light
    		OFF or ON
    		-
    Indicat. Lamp Tail
    		Tail indicator light
    		OFF or ON
    		-
    Indicat. Lamp Fr FOG
    		Front fog indicator light
    		OFF or ON
    		-
    Indicat. Lamp Rr FOG
    		Rear fog indicator light
    		OFF or ON
    		-
    Indicat. Precrash*3
    		Precrash warning light
    		OFF or ON
    		-
    Indicat. Lamp Fuel
    		Fuel level warning light
    		OFF or ON
    		-
    Indicat. Lamp ECB
    		Electrically controlled brake warning light
    		OFF or ON
    		-
    Indicat. Oil Pressure
    		Oil pressure warning light
    		OFF or ON
    		-
    Indicat. Lamp Cruise
    		Cruise main indicator light
    		OFF or ON
    		-
    Indicat. Lamp Brake
    		Brake warning light
    		OFF or ON
    		-
    Indicat. EPS
    		EPS warning light
    		OFF or ON
    		-
    Master Warning
    		Master warning light
    		OFF or ON
    		-
    Indicat. Clearance Sonar LCD*4
    		Clearance sonar indicator light
    		OFF or ON
    		-
    Indicat. Ready (HV)
    		Ready indicator light
    		OFF or ON
    		-
    Indicat. EV Mode
    		EV mode indicator light
    		OFF or ON
    		-
    Indicat. Radar Cruise*5
    		Cruise main indicator light (constant speed control mode or vehicle-to-vehicle distance control mode)
    		OFF or ON
    		-
    Indicat. SPORT
    		Sport mode indicator light
    		OFF or ON
    		-
    Indicat. ECO MODE
    		ECO mode indicator light
    		OFF or ON
    		-
    Indicat. EV
    		EV indicator light
    		OFF or ON
    		*6
    HV System Indicator
    		Hybrid System Indicator
    		MIN, -50, 0, 100, 200, 300, 400, MAX
    		-
    Meter Display 1
    		Multi-information display
    		All dots in the multi-information display OFF or ON
    		-

    1. *1: with mph units
    2. *2: with km/h units
    3. *3: w/ Pre-crash Safety System
    4. *4: w/ Lexus Parking Assist-sensor System
    5. *5: w/ Dynamic Radar Cruise Control System
    6. *6: Indicator or warning light does not operate when the mode is disabled via customization.