CONDENSER > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT COOLER CONDENSER ASSEMBLY

  1. If the cooler condenser assembly fins are dirty, clean them with water and dry with compressed air.

    NOTICE:
    Do not damage the cooler condenser assembly fins.

  1. If any cooler condenser assembly fins are bent, straighten them using a screwdriver or pliers.



2. INSPECT FOR REFRIGERANT LEAK

  1. Using a halogen leak detector, check pipe joints for refrigerant leaks.

  1. If a refrigerant leak is detected in a joint, check the torque of the joint.