REAR VIEW MONITOR SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
Use the following procedure to troubleshoot the rear view monitor system.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT AUXILIARY BATTERY VOLTAGE

    1. Measure the auxiliary battery voltage with the power switch off.

      Standard Voltage:
      11 to 14 V

      If the voltage is below 11 V, replace or recharge the auxiliary battery before proceeding to the next step.


    NEXT


    3.CUSTOMER PROBLEM ANALYSIS

      NEXT


      4.PROBLEM SYMPTOM CONFIRMATION

        Result:
        Result
        		Proceed to
        Symptom occurs
        		A
        Symptom does not occur
        		B



      		B.
      USE SIMULATION METHOD TO CHECK (Click here)
      A


      5.PROBLEM SYMPTOMS TABLE

      1. Refer to Problem Symptoms Table (Click here).

        Result:
        Result
        		Proceed to
        Fault is not listed in Problem Symptoms Table
        		A
        Fault is listed in Problem Symptoms Table
        		B



      		B.
      Go to step 7
      A


      6.BASED ON MALFUNCTION SYMPTOM, PERFORM TROUBLESHOOTING BELOW

      1. Terminals of ECU (Click here)


      NEXT


      7.ADJUST, REPAIR OR REPLACE

        NEXT


        8.CONFIRMATION TEST

          NEXT

          END