LIGHT CONTROL RHEOSTAT > INSPECTION

for Preparation Click here



1. INSPECT LIGHT CONTROL RHEOSTAT


    E184972E08

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    		Switch Condition
    		Specified Condition
    1 (E) - 3 (RV)
    		Turn the light control rheostat knob fully downwards (MIN.)
    		Below 50 Ω
    1 (E) - 3 (RV)
    		Light control rheostat knob position is between MIN. and MAX.
    		The value changes gradually (Between 0 to 12 kΩ)
    1 (E) - 3 (RV)
    		Turn the light control rheostat knob fully upwards (MAX.)
    		8 to 12 kΩ
    5 (TC) - 7 (T)
    		Light control rheostat knob position is except below
    		Below 50 Ω
    5 (TC) - 7 (T)
    		Turn the light control rheostat knob fully upwards (Tail cancel switch is on)
    		8 to 12 kΩ

    If the value is not as specified, replace the light control rheostat.
    Text in Illustration 
    *a
    		Component with harness connected
    (Light Control Rheostat)