ECM > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work (Click here).



2. REMOVE REAR NO. 2 FLOOR BOARD

  1. Remove the rear No. 2 floor board.



3. REMOVE REAR DECK FLOOR BOX

  1. Remove the rear deck floor box.



4. REMOVE REAR NO. 3 FLOOR BOARD

  1. Remove the rear No. 3 floor board.



5. REMOVE DECK FLOOR BOX RH


    B270546

  1. Remove the clip.

  1. Disengage the 6 guides and remove the deck floor box RH.



6. REMOVE REAR FLOOR BOARD UPPER NO. 3 PLATE


    B270547

  1. Disengage the 4 claws and 2 guides, and remove the rear floor board upper No. 3 plate.



7. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL


8. REMOVE INVERTER WITH CONVERTER ASSEMBLY
(Click here)


9. SEPARATE INVERTER RESERVE TANK ASSEMBLY


    A247950

  1. Remove the 2 bolts and separate the inverter reserve tank assembly.



10. REMOVE ECM


    A247949

  1. Separate the wire harness clamp.



  1. Disconnect the 2 ECM connectors.



      A248575

    1. Disconnect the wire harness clamp.

    2. Push the locks on the 2 levers, then raise the levers, and disconnect the 2 ECM connectors.

      NOTICE:
      After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the connectors.



    A212307

  1. Remove the 2 bolts and ECM.

  1. Remove the 4 screws and 2 ECM brackets.