THROTTLE BODY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT THROTTLE BODY ASSEMBLY

  1. Set the vehicle to inspection mode (Click here).

  1. Start the engine and check that the MIL is not illuminated. After the engine is warmed up, check that the idle speed is within the specified range when the A/C is switched off.

    Standard:
    Condition
    		Engine Idle Speed
    A/C switched off
    		950 to 1050 rpm

    NOTICE:
    1. Be sure to perform this step with all accessories off.
    2. Make sure that park (P) is selected.