REAR BRAKE > DISASSEMBLY

for Preparation Click here



1. REMOVE REAR DISC BRAKE PISTON


    C219091E01

  1. Using SST, remove the rear disc brake piston by turning it counterclockwise.

    SST
    09719-12010   (09719-01030)

    NOTICE:
    1. Do not damage the piston.
    2. Do not allow any brake fluid to spatter.



2. REMOVE CYLINDER BOOT

  1. Remove the cylinder boot from the rear disc brake piston.



3. REMOVE PISTON SEAL


    C116888E05

  1. Using a screwdriver with its tip wrapped with vinyl tape, remove the piston seal from the rear disc brake cylinder assembly.
    Text in Illustration 
    *1
    		Vinyl Tape

    NOTICE:
    Do not damage the inner surface or piston seal groove of the cylinder.



4. REMOVE REAR DISC BRAKE BLEEDER PLUG CAP


5. REMOVE REAR DISC BRAKE BLEEDER PLUG