SLIDING ROOF HOUSING > DISASSEMBLY

for Preparation Click here



1. REMOVE SLIDING ROOF DRIVE GEAR ASSEMBLY


    B270074

  1. Remove the 2 bolts and sliding roof drive gear assembly.

    NOTICE:
    To prevent the sliding roof glass and sliding roof drive gear from being displaced, fully close the sliding roof glass (sliding roof drive cable), and then remove the sliding roof drive gear.



2. REMOVE SUNSHADE TRIM SUB-ASSEMBLY


    B271129

  1. Remove the screw and sliding roof piece sub-assembly LH.

    HINT:
    Use the same procedure for the RH side and LH side.



    B270076

  1. Slide and remove the sunshade trim sub-assembly from the sliding roof housing sub-assembly.