SLIDING ROOF HOUSING > REASSEMBLY

for Preparation Click here



1. INSTALL SUNSHADE TRIM SUB-ASSEMBLY


    B270077

  1. Insert the sunshade trim into the sliding roof housing sub-assembly.



    B271129

  1. Install the sliding roof piece sub-assembly LH with the screw.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }

    HINT:
    Use the same procedure for the RH side and LH side.



2. INSTALL SLIDING ROOF DRIVE GEAR ASSEMBLY


    B270074

  1. Install the sliding roof drive gear assembly with the 2 bolts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }