FRONT EVAPORATOR TEMPERATURE SENSOR > REMOVAL

for Preparation Click here



1. REMOVE AIR CONDITIONING UNIT ASSEMBLY
(Click here)


2. REMOVE BLOWER ASSEMBLY (w/o PTC Heater)

  1. Disconnect the connector and disengage each clamp.



  1. Disengage the 3 screws and guide, and remove the blower assembly.


    E220409



3. REMOVE BLOWER ASSEMBLY (w/ PTC Heater)

  1. Remove the felt tape to the extent that the screw can be removed.



    E220408

  1. Remove the screw and disconnect the quick heater connector.

  1. Disengage each clamp.

  1. Disconnect the connector.



  1. Disengage the 3 screws and guide, and remove the blower assembly.


    E220409



4. REMOVE COOLER EXPANSION VALVE


    E189167

  1. Using a 4 mm hexagon wrench, remove the 2 hexagon bolts and cooler expansion valve.



5. REMOVE COOLER EVAPORATOR SUB-ASSEMBLY


    E189157

  1. Remove the packing.

    NOTICE:
    Remove the packing carefully because it will be reused.



    E189154

  1. Remove the 4 screws.

  1. Disengage the 4 claws and remove the lower heater case.



    E189153

  1. Disengage the clamp and remove the cooler evaporator sub-assembly with the No. 1 cooler thermistor.



    E189151

  1. Remove the 2 O-rings from the cooler evaporator sub-assembly.



6. REMOVE NO. 1 COOLER THERMISTOR


    E193479

  1. Remove the No. 1 cooler thermistor.