FRONT DRIVE SHAFT ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT FRONT DRIVE SHAFT ASSEMBLY


    C211744

  1. Check that there is no excessive play in the outboard joint.

  1. Check that the inboard joint slides smoothly in the thrust direction.

  1. Check that there is no excessive play in the radial directions of the inboard joint.



    C157783E02

  1. Check the boots for damage.

    NOTICE:
    Keep the drive shaft assembly level during inspection.

    HINT:
    For dimension (A), refer to the following values.

    Dimension (A) 
    LH Side
    		RH Side
    552.2 to 560.2 mm
    (1.81 to 1.84 ft.)
    		901.2 to 909.2 mm
    (2.96 to 2.98 ft.)