STEERING KNUCKLE > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedure listed below is for the LH side.



1. INSTALL STEERING KNUCKLE

  1. Secure the steering knuckle between aluminum plates in a vise.

    NOTICE:
    Do not overtighten the vise.

  1. Install the front axle hub sub-assembly and front disc brake dust cover with the 4 bolts.

    Torque:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }



2. INSTALL FRONT LOWER BALL JOINT ASSEMBLY

  1. Secure the front axle assembly in a vise.

    NOTICE:
    When using a vise, do not overtighten it.

  1. Install the front lower ball joint assembly to the front axle assembly with the nut.

    Torque:
    71 N*m{ 724 kgf*cm , 52 ft.*lbf }

  1. Install a new clip.

    NOTICE:
    Further tighten the nut up to 60° if the holes for the clip are not aligned.



3. INSTALL FRONT AXLE ASSEMBLY
(Click here)