ELECTRICAL KEY OSCILLATOR (for Front Floor) > INSTALLATION

for Preparation Click here



1. INSTALL NO. 1 ELECTRICAL KEY OSCILLATOR

  1. Engage the clamp and install the No. 1 electrical key oscillator.

    NOTICE:
    Be careful when installing the electrical key oscillator. If the oscillator is dropped, replace it with a new one.

  1. Connect the connector.



2. INSTALL CONSOLE BOX LH

  1. Engage the guide and 2 claws.

  1. Engage the 3 clips.

  1. Install the console box LH with the bolt <A> and clip.



3. INSTALL CONSOLE BOX INSERT

  1. Engage the 2 claws and 2 clips to install the console box insert.



4. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY

  1. Connect each connector.

  1. Engage the clamp.

  1. Engage the 2 guides and 6 claws to install the integration control and panel assembly.



5. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY


    B269928

  1. Turn the shift lever knob clockwise and install the shift lever knob sub-assembly.



6. INSTALL REAR CONSOLE BOX ASSEMBLY
(Click here)