WASHER NOZZLE (for Front Side) > ADJUSTMENT

for Preparation Click here



1. REMOVE WASHER NOZZLE SUB-ASSEMBLY


    E220046E01

  1. Using a screwdriver, disengage the 2 claws and separate the washer nozzle sub-assembly as shown in the illustration.
    Text in Illustration 
    *1
    		Protective Tape

    NOTICE:
    Be careful not to damage the windshield.

    HINT:
    Tape the screwdriver tip before use.



    E220048

  1. Remove the washer nozzle sub-assembly from the washer hose.

    NOTICE:
    Washer nozzles cannot be reused.



2. ADJUST WASHER NOZZLE SUB-ASSEMBLY


  1. Select a washer nozzle so that the contact area is within the standard. Replace the washer nozzle with the selected one.


    E220049E01



3. INSTALL WASHER NOZZLE SUB-ASSEMBLY

  1. Connect a new washer nozzle sub-assembly to the washer hose.



    E220047E01

  1. Engage the 2 claws to install the washer nozzle sub-assembly as shown in the illustration.