RAIN SENSOR > INSTALLATION

for Preparation Click here

HINT:

Rain sensor tape is reusable. Only replace the tape if it is damaged or contaminated.

1. Clean the rain sensor sensing portion with a piece of cloth, etc.
   

2. Peel off the smaller release sheet, and then attach the rain sensor tape on the rain sensor sensing portion as shown in the illustration.
   

   Standard Clearance 

   Area	Measurement
   A	13.5 mm (0.532 in.)
   B	7.25 mm (0.285 in.)

   Text in Illustration 

   *1	Rain Sensor Tape

   NOTICE:

   Use your fingers to push out any air bubbles from under the tape.

1. Clean the windshield glass with a piece of cloth, etc.
   

   NOTICE:

   1. Make sure that there is no rain sensor tape residue remaining on the windshield glass. If there is, remove the residue.
      
   2. If there is any rain sensor tape residue remaining on the windshield glass, replace the tape.
      

2. When installing a new rain sensor or replacing the rain sensor tape:
   
   

   1. Peel off the release sheet.
      

      HINT:

      Do not touch the silicone coated surfaces.

3. Gradually attach the rain sensor to the glass surface to prevent air bubbles from forming between them.
   

   HINT:

   Do not touch the silicone coated or glass surfaces.

4. Push in the stopper.
   

   Text in Illustration 

   *1

   Stopper

5. Connect the connector.
   

1. Engage the 2 claws and connect the rain sensor cover.
   

2. Engage the 2 guides and install the rain sensor cover as shown in the illustration.