WASHER LEVEL WARNING SWITCH > INSPECTION

for Preparation Click here

HINT:

The following check should be performed with the windshield washer motor and pump installed to the washer jar.

1. Fill the washer jar with washer fluid.
   

2. Measure the resistance according to the value(s) in the table below.
   

   Standard Resistance:

   Tester Connection	Condition	Specified Condition
   1 (S) - 2 (E)	Fluid volume is more than 800 ml	10 kΩ or higher
   1 (S) - 2 (E)	Fluid volume is less than 600 ml	Below 1 Ω

   Text in Illustration 

   *a	Component without harness connected (Level Warning Switch Assembly)

   If the result is not as specified, replace the level warning switch assembly.