WASHER LEVEL WARNING SWITCH > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL RH


2. REMOVE FRONT FENDER LINER RH


    E220607E01

  1. Using a screwdriver, turn each pin 90 degrees counterclockwise and remove the 2 pin hold clips.



    E220608

  1. Using a 4 mm hexagon wrench, remove the 3 screws.



    E220609E01

  1. Remove the 6 screws and bolt.

  1. Remove the 6 clips and 2 grommets and front fender liner RH.

    HINT:
    The grommets need to be replaced with new ones because they will break when they are removed.

    Text in Illustration 
    *1
    		Grommet



3. DRAIN WASHER FLUID


    E220057

  1. Disconnect the washer hose from the rear washer motor and pump assembly, and drain the washer fluid.

    HINT:
    Use a container to collect the washer fluid.



4. REMOVE LEVEL WARNING SWITCH ASSEMBLY


    E221493

  1. Disconnect the connector.

  1. Remove the level warning switch assembly as shown in the illustration.