ULTRASONIC SENSOR (for Rear Side) > INSTALLATION

for Preparation Click here



1. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER (for Corner Sensor)


    E220149E01

  1. Engage the 4 claws and install the No. 1 ultrasonic sensor retainer to the rear bumper assembly.
    Text in Illustration 
    *a
    		Keyhole
    *b
    		Slit

    HINT:
    When installing the retainer, align the keyhole and slit as shown in the illustration.



2. INSTALL ULTRASONIC SENSOR CLIP (for Corner Sensor)


  1. for LH Side:



      E221223

    1. Engage the claw to install the ultrasonic sensor clip to the No. 1 ultrasonic sensor assembly.



  1. for RH Side:



      E223123

    1. Engage the claw to install the ultrasonic sensor clip to the No. 1 ultrasonic sensor assembly.



3. INSTALL ULTRASONIC SENSOR ASSEMBLY (for Corner Sensor)

  1. Engage the 2 claws to install the ultrasonic sensor assembly to the No. 1 ultrasonic sensor retainer.

  1. Engage the clamp.



4. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER (for Back Sensor)


    E220148E01

  1. Engage the 4 claws and install the No. 1 ultrasonic sensor retainer to the rear bumper assembly.
    Text in Illustration 
    *a
    		Keyhole
    *b
    		Slit

    HINT:
    1. When installing the retainer, align the keyhole and slit as shown in the illustration.
    2. The illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.



5. INSTALL ULTRASONIC SENSOR CLIP (for Back Sensor)


    E220807

  1. Engage the claw to install the ultrasonic sensor clip to the No. 1 ultrasonic sensor assembly.

    HINT:
    The illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.



6. INSTALL ULTRASONIC SENSOR ASSEMBLY (for Back Sensor)

  1. Engage the 2 claws to install the ultrasonic sensor assembly to the No. 1 ultrasonic sensor retainer.

  1. Engage the clamp.



7. INSTALL REAR BUMPER ASSEMBLY
(Click here)