ULTRASONIC SENSOR (for Rear Side) > REMOVAL

for Preparation Click here



1. REMOVE REAR BUMPER ASSEMBLY
(Click here)


2. REMOVE ULTRASONIC SENSOR ASSEMBLY (for Corner Sensor)


  1. for LH Side:



      E220144

    1. Disconnect the connector.



      2. E220145

    2. Disengage the clamp.

    3. Disengage the 2 claws and remove the ultrasonic sensor assembly.



  1. for RH Side:



      E220137

    1. Disconnect the connector.



      2. E220138

    2. Disengage the clamp.

    3. Disengage the 2 claws and remove the ultrasonic sensor assembly.



3. REMOVE ULTRASONIC SENSOR CLIP (for Corner Sensor)


  1. for LH Side:



      E221222E01

    1. Using a screwdriver, disengage the claw and remove the ultrasonic sensor clip from the No. 1 ultrasonic sensor.
      Text in Illustration 
      *1
      		Protective Tape



  1. for RH Side:



      E223122E01

    1. Using a screwdriver, disengage the claw and remove the ultrasonic sensor clip from the No. 1 ultrasonic sensor.
      Text in Illustration 
      *1
      		Protective Tape



4. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER (for Corner Sensor)


    E220136

  1. Disengage the 4 claws and remove the No. 1 ultrasonic sensor retainer from the rear bumper assembly.



5. REMOVE ULTRASONIC SENSOR ASSEMBLY (for Back Sensor)


    E220141

  1. Disconnect the connector.

    HINT:
    The illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.



    E220142

  1. Disengage the clamp.

  1. Disengage the 2 claws and remove the ultrasonic sensor assembly.

    HINT:
    The illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.



6. REMOVE ULTRASONIC SENSOR CLIP (for Back Sensor)


    E220808E01

  1. Using a screwdriver, disengage the claw and remove the ultrasonic sensor clip from the No. 1 ultrasonic sensor.
    Text in Illustration 
    *1
    		Protective Tape

    HINT:
    The illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.



7. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER (for Back Sensor)


    E220143

  1. Disengage the 4 claws and remove the No. 1 ultrasonic sensor retainer from the rear bumper assembly.

    HINT:
    The illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.