AMPLIFIER ANTENNA > REMOVAL

for Preparation Click here



1. REMOVE UPPER BACK DOOR TRIM PANEL ASSEMBLY (for Back Door)


    B270183

  1. Using a moulding remover, disengage the 4 clips and 4 claws, and remove the upper back door trim panel assembly.



2. REMOVE BACK DOOR SIDE GARNISH LH (for Back Door)


    B270184

  1. Disengage the 2 clips, 2 claws and guide, and remove the back door side garnish LH.



3. REMOVE BACK DOOR SIDE GARNISH RH (for Back Door)


    B270185

  1. Disengage the 2 clips, 2 claws and guide, and remove the back door side garnish RH.



4. REMOVE BACK DOOR TRIM BOARD ASSEMBLY (for Back Door)


    B270186

  1. Using a screwdriver with its tip wrapped in protective tape, slide the handle plate of the back door trim board to disengage it.



    B270188

  1. Disengage the 13 clips and remove the back door trim board assembly.



5. REMOVE AMPLIFIER ANTENNA ASSEMBLY (for Back Door)


    E220152

  1. Disconnect the 2 connectors.

  1. Remove the bolt and amplifier antenna assembly.



6. REMOVE ROOF ANTENNA POLE SUB-ASSEMBLY (for Roof Side)
w/ Audio: (Click here)
w/o Audio: (Click here)


7. REMOVE ROOF HEADLINING ASSEMBLY (for Roof Side)
(Click here)


8. REMOVE ROOF ANTENNA ASSEMBLY (for Roof Side)


    E221246

  1. Disconnect the connector.



    E223127

  1. Remove the antenna nut.



    E220089

  1. Disengage the 2 claws and remove the roof antenna assembly.