MICROPHONE > REMOVAL

for Preparation Click here



1. REMOVE MAP LIGHT ASSEMBLY

  1. Open the overhead console.



    E220652E01

  1. Disengage the 4 clips and 3 guides as shown in the illustration.

  1. Disconnect the connector and remove the map light assembly.



2. DISCONNECT THEFT WARNING RADAR SENSOR (w/ Intrusion Sensor)


  1. w/o Sliding Roof:



      B269167

    1. Peel back the tape used to secure the cord only to the extent that allows removal of the cord.

      HINT:
      Tape is not available as a supply part. Try to leave as much tape as possible on the map light assembly so that the tape can be reused.



      2. B269168

    2. Disconnect the connector and disengage the clamp.



      3. B269169

    3. Peel back the tape used to secure the cord only to the extent that allows removal of the cord.

      HINT:
      Tape is not available as a supply part. Try to leave as much tape as possible on the map light assembly so that the tape can be reused.



      4. B269170

    4. Remove the 2 screws and disconnect the connector.

    5. Disengage the 2 clamps.



  1. w/ Sliding Roof:



      B269158

    1. Remove the 2 screws and disconnect the connector.



      2. B269159

    2. Disengage the 6 clamps.



3. REMOVE AMPLIFIER MICROPHONE ASSEMBLY


    E220155

  1. Peel back the tape used to secure the cord only to the extent that allows removal of the cord.

    HINT:
    Tape is not available as a supply part. Try to leave as much tape as possible on the map light assembly so that the tape can be reused.



    E220156

  1. Disconnect the connector and disengage the guide.



    E220157

  1. Remove the 7 screws and cover.



    E220158

  1. Remove the board as shown in the illustration.



    E220159

  1. Remove the map knob guide as shown in the illustration.



    E220161

  1. Disengage the 2 claws.