ENGINE HOOD COURTESY SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL SECURITY COURTESY SWITCH (HOOD LOCK ASSEMBLY)


    B270693

  1. Apply MP grease to the sliding areas of the lock.

  1. Connect the hood lock control cable.

  1. Install the hood lock assembly with the 2 bolts and hood lock bolt.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Install a new hood lock nut cap.

  1. Engage the clamp.

  1. Connect the connector.



2. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)


    E214951E01

  1. Tighten the 3 bolts on the millimeter wave radar sensor assembly.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

    HINT:
    Tighten the bolts in the order indicated in the illustration.

  1. Connect the connector.



3. INSTALL FRONT BUMPER ASSEMBLY
(Click here)


4. INSPECT HOOD SUB-ASSEMBLY


  1. Check that the clearance measurements of areas *a through *e are within each standard range.


    B270217E01


    Standard Clearance 
    Area
    		Measurement
    		Area
    		Measurement
    *a
    		3.3 to 7.3 mm (0.130 to 0.287 in.)
    		*b
    		-1.5 to 1.5 mm (-0.0591 to 0.0591 in.)
    *c
    		5.65 to 9.65 mm (0.222 to 0.380 in.)
    		*d
    		2.5 to 5.5 mm (0.0984 to 0.217 in.)
    *e
    		-0.6 to 2.4 mm (-0.0236 to 0.0945 in.)
    		-
    		-



5. ADJUST HOOD SUB-ASSEMBLY
(Click here)


6. ADJUST MILLIMETER WAVE RADAR SENSOR (w/ Dynamic Radar Cruise Control System)
(Click here)