ENGINE HOOD COURTESY SWITCH > INSPECTION

for Preparation Click here



1. INSPECT SECURITY COURTESY SWITCH (HOOD LOCK ASSEMBLY)


  1. Measure the resistance according to the value(s) in the table below.


    B273442E01

    Standard Resistance:
    Tester Connection
    		Condition
    		Specified Condition
    1 (+) - 4 (E)
    		Locked
    		10 kΩ or higher
    1 (+) - 4 (E)
    		Unlocked
    		Below 1 Ω
    2 (HWM+) - 3 (HWM-)
    		Always
    		Below 1 Ω


    Text in Illustration 
    *A
    		for LHD
    		*B
    		for RHD
    *1
    		Unlocked
    		*2
    		Locked
    *a
    		Component without harness connected
    (Security Courtesy Switch (Hood Lock Assembly))
    		-
    		-
    If the result is not as specified, replace the security courtesy switch (hood lock assembly).