PURGE VALVE > INSTALLATION

for Preparation Click here



1. INSTALL PURGE VSV

  1. Install the purge VSV with the bolt.

    Torque:
    21 N*m{ 214 kgf*cm , 15 ft.*lbf }

  1. Connect the 2 fuel vapor feed hoses and connector to the purge VSV.



2. INSTALL AIR CLEANER CASE

  1. Install the air cleaner case with the 2 bolts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }

  1. Install the water hose to the hose clamp.

  1. Install the air cleaner filter element sub-assembly.



3. INSTALL INLET AIR CLEANER ASSEMBLY

  1. Install the inlet air cleaner assembly to the air cleaner case.

  1. Install the inlet air cleaner assembly with the 2 bolts and 2 clips.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }

  1. Connect the wire harness clamp to the inlet air cleaner assembly.

  1. Install the water hose to the hose clamp.



4. INSTALL AIR CLEANER CAP SUB-ASSEMBLY

  1. Install the air cleaner cap sub-assembly with the 2 clamps.

  1. Tighten the hose clamp.

  1. Connect the mass air flow meter connector.

  1. Connect the wire harness clamp.



5. INSTALL NO. 2 CYLINDER HEAD COVER


    A248095

  1. Engage the 3 clips to install the cover.

    NOTICE:
    1. Be sure to engage the clips securely.
    2. Do not apply excessive force or hit the cover to engage the clips. This may cause the cover to break.