PURGE VALVE > INSPECTION

for Preparation Click here



1. INSPECT PURGE VSV

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    		Condition
    		Specified Condition
    1 - 2
    		20°C (68°F)
    		23 to 26 Ω

    If the result is not as specified, replace the purge VSV.



    A212676E03

  1. Apply auxiliary battery voltage between the terminals of the purge VSV and check that the following occurs when blowing air into port E.

    OK:
    Measurement Condition
    		Specified Condition
    Auxiliary battery voltage applied between terminals 1 and 2
    		Air flows from port F
    Auxiliary battery voltage not applied between terminals 1 and 2
    		Air does not flow

    Text in Illustration 
    *a
    		Air
    If the result is not as specified, replace the purge VSV.