PURGE VALVE > REMOVAL

for Preparation Click here



1. REMOVE NO. 2 CYLINDER HEAD COVER


    A248095E01

  1. Remove the 3 clips and No. 2 cylinder head cover.

    NOTICE:
    1. Disengage the clips in the order shown in the illustration.
    2. Attempting to disengage both front and rear clips at the same time may cause the cover to break.
    3. Pull the cover straight up to remove. Attempting to pull the cover forward may cause it to break.



2. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    A247952

  1. Disconnect the mass air flow meter connector.



    A247953

  1. Separate the water hose from the hose clamp.

  1. Release the 2 clamps.

  1. Loosen the hose clamp and remove the air cleaner cap.



3. REMOVE INLET AIR CLEANER ASSEMBLY


    A247954

  1. Separate the water hose from the hose clamp.



    A247955

  1. Separate the wire harness clamp from the inlet air cleaner assembly.

  1. Remove the 2 bolts, 2 clips and inlet air cleaner assembly.



4. REMOVE AIR CLEANER CASE

  1. Remove the air cleaner filter element sub-assembly.



    A247956

  1. Separate the hose from the hose clamp.

  1. Remove the 2 bolts and air cleaner case.



5. REMOVE PURGE VSV


    A212673

  1. Disconnect the connector and 2 fuel vapor feed hoses.



    A212674

  1. Remove the bolt and purge VSV.