PCV VALVE > INSTALLATION

for Preparation Click here



1. INSTALL VENTILATION VALVE SUB-ASSEMBLY

  1. Apply adhesive to 2 or 3 threads of the ventilation valve sub-assembly.

    Adhesive:
    Toyota genuine adhesive 1324, three bond 1324 or equivalent

  1. Using a ball joint lock nut wrench (22 mm), install the ventilation valve sub-assembly.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

    NOTICE:
    Use the torque value compensation formula to calculate the torque value for use when a torque wrench is combined with a tool such as a ball joint lock nut wrench (Click here).

  1. Install the ventilation hose to the ventilation valve sub-assembly.



2. INSTALL NO. 1 ENGINE UNDER COVER


3. INSTALL AIR CLEANER CASE

  1. Install the air cleaner case with the 2 bolts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }

  1. Install the water hose to the hose clamp.

  1. Install the air cleaner filter element sub-assembly.



4. INSTALL INLET AIR CLEANER ASSEMBLY

  1. Install the inlet air cleaner assembly to the air cleaner case.

  1. Install the inlet air cleaner assembly with the 2 bolts and 2 clips.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }

  1. Connect the wire harness clamp to the inlet air cleaner assembly.

  1. Install the water hose to the hose clamp.



5. INSTALL AIR CLEANER CAP SUB-ASSEMBLY

  1. Install the air cleaner cap sub-assembly with the 2 clamps.

  1. Tighten the hose clamp.

  1. Connect the mass air flow meter connector.

  1. Connect the wire harness clamp.



6. INSTALL NO. 2 CYLINDER HEAD COVER


    A248095

  1. Engage the 3 clips to install the cover.

    NOTICE:
    1. Be sure to engage the clips securely.
    2. Do not apply excessive force or hit the cover to engage the clips. This may cause the cover to break.