STEREO JACK ADAPTER ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL NO. 1 STEREO JACK ADAPTER ASSEMBLY

  1. Engage the 2 claws to install the No. 1 stereo jack adapter assembly.



2. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY

  1. Connect each connector.

  1. Engage the clamp.



    B269924

  1. Engage the 12 claws to install the upper console panel sub-assembly.

    NOTICE:
    When installing the upper console panel sub-assembly, make sure not to pinch the wire harness connected to the front end of the remote touch (w/ Navigation System).

  1. Close the console compartment door.



3. INSTALL UPPER NO. 1 CONSOLE PANEL GARNISH

  1. Engage the 3 guides, clip and 4 claws to install the upper No. 1 console panel garnish.



4. INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH

  1. Engage the 2 guides, clip and 5 claws to install the upper No. 2 console panel garnish.



5. INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL


    B271367

  1. Engage the 4 guides and 7 claws to install the lower center instrument panel finish panel.

  1. Close the glove compartment door.