ELECTRONIC SHIFT LEVER SYSTEM > DTC CHECK / CLEAR

for Preparation Click here



CHECK FOR DTCS (Using the intelligent tester)

  1. Connect the intelligent tester to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the intelligent tester on.

  4. Enter the following menus: Chassis / Transmission Control / DTC.

  5. Check for DTCs and freeze frame data, and then write them down.

  6. Check the details of the DTCs.


CHECK FOR DTCS (Systems other than the transmission control ECU assembly)

HINT:
The transmission control ECU assembly maintains communication with other ECUs, including the power management control ECU. Therefore, if the transmission control ECU assembly outputs a warning, it is necessary to check and record the DTCs of all systems.

  1. If DTCs are present, check the relevant systems.

    HINT:
    If DTCs for the CAN communication system are present in addition to other DTCs, first troubleshoot and repair any malfunctions in the CAN communication system.


CLEAR DTCS (Using the intelligent tester)

  1. Connect the intelligent tester to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the intelligent tester on.

  4. Enter the following menus: Chassis / Transmission Control / DTC.

  5. Clear the DTCs and freeze frame data.

    NOTICE:
    1. It may not be possible to clear the following DTCs using the intelligent tester: C2300 (Actuator System Malfunction), C2301 (Shift Changing Time Malfunction), C2303 (Short in Power Source Relay Circuit), C2304 (Open or Short Circuit in U Phase), C2305 (Open or Short Circuit in V Phase), C2306 (Open or Short Circuit in W Phase), C2307 (Power Supply) and C2309 (Open in B+ Circuit). In such cases, disconnect the P CON MAIN fuse and wait for at least 60 seconds to clear the DTCs after the repair.
    2. Clearing the DTCs will also clear the freeze frame data.


CLEAR DTCS (Without using the intelligent tester)

  1. Turn the power switch off.

  2. Remove the P CON MAIN fuse from the engine room junction block assembly located inside the engine compartment for more than 60 seconds.

  3. Check for DTCs again to see if the DTCs are cleared.

    NOTICE:
    1. If DTCs are output, repair the parts by following the diagnostic trouble code chart.
    2. Clearing the DTCs will also clear the freeze frame data.