ELECTRONIC SHIFT LEVER SYSTEM > FAIL-SAFE CHART

for Preparation Click here


If the transmission control ECU assembly detects a malfunction, the fail-safe functions shown in the table below are activated.

DTC No.
Fail-safe Function
Problem Symptoms
C2300
C2301
Only park (P) release operation is possible and the shift control actuator assembly is activated.
Either of the following may occur:
  1. The shift state (P, R, N, D or B) is not indicated correctly on the meter.
  2. Although the shift state is indicated on the combination meter, the vehicle cannot be driven.
C2303
-
The auxiliary battery is discharged.
C2304
C2305
C2306
The P CON MTR relay (transaxle parking lock control relay) is turned off.
The parking lock mechanism cannot be switched.
C2307
The P CON MTR relay (transaxle parking lock control relay) is turned off.
Either of the following may occur:
  1. The shift state (P, R, N, D or B) is not indicated correctly on the meter.
  2. Although the shift state is indicated on the combination meter, the vehicle cannot be driven.
C2308
-
Either of the following may occur:
  1. The parking lock mechanism cannot be switched.
  2. The key reminder buzzer sounds constantly.
C2309
The P CON MTR relay (transaxle parking lock control relay) is turned off.
The parking lock mechanism cannot be switched.
C2311
-
The parking lock mechanism cannot be switched.