ELECTRONIC SHIFT LEVER SYSTEM > FREEZE FRAME DATA

for Preparation Click here



CHECK FREEZE FRAME DATA

HINT:
The transmission control ECU assembly records vehicle and driving condition information as freeze frame data the moment a DTC is stored. Freeze frame data can help determine the vehicle conditions when the malfunction occurred and help duplicate conditions when troubleshooting.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the intelligent tester on.

  4. Enter the following menus: Chassis / Transmission Control / DTC.

  5. Select a DTC in order to display its freeze frame data.


LIST OF FREEZE FRAME DATA

Tester Display
Measurement Item
Reference Value
Shift Pos Display (P)
Shift position display (P)
ON / OFF
Shift Pos Display (Not P)
Shift position display (not P)
ON / OFF
Master Caution Display
Master caution display
Disp / Nondisp
PSW Indicator Mode
PSW indicator mode
OFF / ON
U Phase Voltage Value
U phase voltage value
0 to 39 V
V Phase Voltage Value
V phase voltage value
0 to 39 V
W Phase Voltage Value
W phase voltage value
0 to 39 V
Battery Voltage Value
BATT voltage value
0 to 19 V
IG(+B) Voltage Value
IG (+B) voltage value
0 to 19 V
Cmplte of Learn Lck Pos
Completion of lock position learning
OK / NG
Cmplte of Learn Unlck Pos
Completion of unlock position learning
OK / NG
# of Trip Cuntr after Learn
Counter for number of trip after learning
0 to 65535
Main Relay for Motor Drive
P CON MTR relay (transaxle parking lock control relay) for motor drive
ON / OFF
U Phase Crnt-Carry Status
U phase current-carrying status
ON / OFF
V Phase Crnt-Carry Status
V phase current-carrying status
ON / OFF
W Phase Crnt-Carry Status
W phase current-carrying status
ON / OFF
U Phase Voltage Status
U phase voltage status
ON / OFF
V Phase Voltage Status
V phase voltage status
ON / OFF
W Phase Voltage Status
W phase voltage status
ON / OFF
Battery Voltage Status
BATT voltage status
ON / OFF
IG(+B) Phase Vol Status
IG (+B) phase voltage status
ON / OFF
ACC Condition Signal
ACC condition signal
ON / OFF
Init Drv Cntrl Completed
Initial drive control completed
OK / NG
Cmplte of Detct Lck Pos
Completion of detecting lock position
OK / NG
Cmplte of Detct Unlck Pos
Completion of detecting unlock position
OK / NG
P/Not P Move Shft Range
P/Not P movable shift range
Set / Unset
Main Relay
P CON MTR relay (transaxle parking lock control relay)
Normal / Abnoml
Current flag record
Current flag record
ON / OFF
Fail Rank
Fail rank
0 to 255
Detail Information #
-
-