STOP LIGHT SWITCH > INSPECTION

for Preparation Click here



1. INSPECT STOP LIGHT SWITCH ASSEMBLY


    E182485E07

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    		Switch Condition
    		Specified Condition
    1 - 2
    		Pushed
    		10 kΩ or higher
    Not pushed
    		Below 1 Ω
    3 - 4
    		Pushed
    		Below 1 Ω
    Not pushed
    		10 kΩ or higher

    Text in Illustration 
    *a
    		Component without harness connected
    (Stop Light Switch Assembly)
    If the result is not as specified, replace the stop light switch assembly.