CAN COMMUNICATION SYSTEM > Skid Control ECU Communication Stop Mode

for Preparation Click here


DESCRIPTION


Detection Item
Symptom
Trouble Area
Skid Control ECU Communication Stop Mode
  1. "ABS/VSC/TRC" is not displayed on the "Communication Bus Check" screen of the intelligent tester.
  2. Applies to Skid Control ECU Communication Stop Mode in DTC Combination Table.
  1. Skid control ECU branch line or connector
  2. Power source circuit of Skid control ECU
  3. Skid control ECU (Brake booster with master cylinder assembly)

WIRING DIAGRAM


C235821E04


C235821E05


INSPECTION PROCEDURE

NOTICE:
  1. Turn the power switch off before measuring the resistances between CAN main bus lines and between CAN branch lines.
  2. Turn the power switch off before inspecting CAN bus lines for a ground short.
  3. After the power switch is turned off, check that the key reminder warning system and light reminder warning system are not operating.
  4. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the power switch, any other switches or the doors. If any doors need to be opened in order to check connectors, open the doors and leave them open.

HINT:
  1. Operating the power switch, any other switches or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
  2. Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below may help determine the cause of the malfunction.

1.CHECK DTC (BRAKE CONTROL SYSTEM)

  1. Connect the intelligent tester to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the intelligent tester on.

  1. Enter the following menus: Chassis / ABS/VSC/TRC / DTC.

    OK:
    DTC C1241 is not output.



NG
GO TO DIAGNOSIS PROCEDURES INDICATED BY OUTPUT DTC (Click here)
OK


2.CHECK CAN BUS LINE FOR DISCONNECTION (SKID CONTROL ECU BRANCH LINE)

  1. Turn the power switch off.



    C209401E69

  1. Disconnect the skid control ECU (brake booster with master cylinder assembly) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    		Switch Condition
    		Specified Condition
    A61-37 (CA1H) - A61-38 (CA1L)
    		Power switch off
    		54 to 69 Ω

    Text in Illustration 
    *a
    		Front view of wire harness connector
    (to Skid Control ECU)

    Result:
    Result
    		Proceed to
    OK (for LHD)
    		A
    OK (for RHD)
    		B
    NG
    		C



B
REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY (SKID CONTROL ECU) (Click here)

C
REPAIR OR REPLACE CAN BRANCH LINE OR CONNECTOR (SKID CONTROL ECU)
A

REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY (SKID CONTROL ECU) (Click here)