FRONT SEAT ASSEMBLY (for Manual Seat) > REMOVAL

for Preparation Click here



1. PRECAUTION

CAUTION:
  1. Be sure to read Precaution thoroughly before servicing (Click here).
  2. If the side airbag was deployed, replace the front seat airbag assembly and separate type front seatback spring assembly with a new one.

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).



2. REMOVE REAR NO. 2 FLOOR BOARD

  1. Remove the rear No. 2 floor board.



3. REMOVE REAR DECK FLOOR BOX

  1. Remove the rear deck floor box.



4. REMOVE REAR NO. 3 FLOOR BOARD

  1. Remove the rear No. 3 floor board.



5. REMOVE DECK FLOOR BOX RH


    B270546

  1. Remove the clip.

  1. Disengage the 6 guides and remove the deck floor box RH.



6. REMOVE REAR FLOOR BOARD UPPER NO. 3 PLATE


    B270547

  1. Disengage the 4 claws and 2 guides, and remove the rear floor board upper No. 3 plate.



7. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



8. REMOVE FRONT SEAT HEADREST ASSEMBLY


9. REMOVE FRONT OUTER SEAT TRACK BRACKET COVER


    B269596

  1. Disengage the 2 claws and remove the front outer seat track bracket cover.



10. REMOVE FRONT INNER SEAT TRACK BRACKET COVER


    B269592

  1. Disengage the 2 claws and remove the front inner seat track bracket cover.



11. REMOVE REAR OUTER SEAT TRACK BRACKET COVER

  1. Lift up the seat track adjusting handle and move the seat to the foremost position.



    B269600

  1. Disengage the 2 claws and remove the rear outer seat track bracket cover.



12. REMOVE REAR INNER SEAT TRACK BRACKET COVER


    B269602

  1. Disengage the 2 claws and remove the rear inner seat track bracket cover.



13. REMOVE FRONT SEAT ASSEMBLY


    B270229

  1. Remove the 2 bolts on the rear side of the seat.

  1. Lift up the seat track adjusting handle and move the seat to the rearmost position.



    B270231

  1. Remove the 2 bolts on the front side of the seat.

  1. Disconnect each connector and clamp under the seat.

  1. Lift up the seat track adjusting handle and move the seat to the center position. Also, operate the reclining adjuster release handle and move the seatback to the upright position.

  1. Remove the front seat assembly.

    NOTICE:
    Be careful not to damage the vehicle body.