FRONT SEATBACK HEATER (for Power Seat) > INSTALLATION

for Preparation Click here

1. Using hog ring pliers, install the separate type front seatback cover (front seatback heater assembly) to the separate type front seatback pad with 14 new hog rings.
   

   NOTICE:

   1. Be careful not to damage the cover.
      
   2. When installing the hog rings, take care to minimize wrinkles as much as possible.
      

1. Temporarily install the separate type front seatback cover with pad to the front seatback spring assembly.
   

2. Attach the bracket of the separate type front seatback cover to the front seatback spring assembly in the order indicated in the illustration.
   

3. Install the separate type front seatback cover bracket with the nut.
   

   Torque:

   5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

   CAUTION:

   1. For vehicles with side airbags, the seatback cover must be securely installed. Otherwise, the side airbags may not deploy properly.
      
   2. Make sure that the strap is not twisted after installing the bracket.
      
   3. Install the bracket securely.
      

4. Engage the 4 claws to install the 2 front seat headrest supports.
   

5. Engage the fastener.
   

6. Close the 2 fasteners.
   

7. Using hog ring pliers, install 5 new hog rings.
   

   NOTICE:

   1. Be careful not to damage the cover.
      
   2. When installing the hog rings, take care to minimize wrinkles as much as possible.
      

8. Engage the 2 fasteners.