FRONT SEAT CUSHION HEATER (for Manual Seat) > REMOVAL |
| 1. REMOVE FRONT SEAT ASSEMBLY |
| 2. REMOVE RECLINING ADJUSTER RELEASE HANDLE |
![]() |
Using a screwdriver with its tip wrapped with protective tape, disengage the claw and remove the reclining adjuster release handle.
| *1 | Protective Tape |
| 3. REMOVE VERTICAL ADJUSTING HANDLE (for 6 Way Seat Type) |
![]() |
Remove the screw and vertical adjusting handle.
| 4. REMOVE FRONT SEAT CUSHION SHIELD |
![]() |
Remove the screw.
Disengage the 11 claws and clip, and remove the front seat cushion shield.
| 5. REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Driver Side) |
Disconnect each connector.
Disengage each clamp under the front seat assembly.
![]() |
Remove the nut and front seat inner belt assembly.
| 6. REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Front Passenger Side) |
Disconnect each connector.
Disengage each clamp under the front seat assembly.
![]() |
Remove the nut and front seat inner belt assembly.
| 7. REMOVE FRONT SEAT INNER CUSHION SHIELD |
![]() |
Disengage the 4 claws and remove the front seat inner cushion shield.
| 8. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD |
![]() |
Disconnect the rubber band.
![]() |
Disengage the fastener and separate the seat side airbag wire harness.
w/ Seat Heater System:
![]() |
Disconnect the connector.
Disengage the clamp and disconnect the seat heater wire harness.
![]() |
Disconnect the connector.
Disengage the 2 clamps and disconnect the seat heater wire harness.
for Front Passenger Side:
![]() |
Disengage the clamp and disconnect the connector as shown in the illustration.
![]() |
Disengage the 4 hooks.
![]() |
Disengage each hook and remove the separate type front seat cushion cover with pad.
| 9. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER (FRONT SEAT CUSHION HEATER ASSEMBLY) |
![]() |
Remove the 2 hog rings.
![]() |
Remove the 21 hog rings and the separate type front seat cushion cover (front seat cushion heater assembly).