TURN SIGNAL FLASHER ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT TURN SIGNAL FLASHER ASSEMBLY


    E223979E01

  1. Disconnect the H35 turn signal flasher assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    		Switch Condition
    		Specified Condition
    H35-1 (IG) - Body ground
    		Power switch off
    		Below 1 V
    Power switch on (IG)
    		11 to 14 V
    H35-4 (B) - Body ground
    		Always
    		11 to 14 V

    Text in Illustration 
    *a
    		Front view of wire harness connector
    (to Turn Signal Flasher Assembly)
    If the result is not as specified, repair or replace the wire harness or connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    		Switch Condition
    		Specified Condition
    H35-5 (EL) - Body ground
    		Turn signal switch off
    		10 kΩ or higher
    Turn signal switch in left turn position
    		Below 1 Ω
    H35-6 (ER) - Body ground
    		Turn signal switch in neutral position
    		10 kΩ or higher
    Turn signal switch in right turn position
    		Below 1 Ω
    H35-7 (E) - Body ground
    		Always
    		Below 1 Ω
    H35-8 (HAZ) - Body ground
    		Hazard warning switch off
    		10 kΩ or higher
    Hazard warning switch on
    		Below 1 Ω

    If the result is not as specified, repair or replace the wire harness or connector.



    E223980E01

  1. Reconnect the H35 turn signal flasher assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    		Switch Condition
    		Specified Condition
    H35-2 (LR) - Body ground
    		Hazard warning switch off
    		Below 1 V
    Hazard warning switch on
    		11 to 14 V (60 to 120 times per minute)
    Turn signal switch off
    		Below 1 V
    Power switch on (IG) and turn signal switch in RH position
    		11 to 14 V (60 to 120 times per minute)
    H35-3 (LL) - Body ground
    		Hazard warning switch off
    		Below 1 V
    Hazard warning switch on
    		11 to 14 V (60 to 120 times per minute)
    Turn signal switch off
    		Below 1 V
    Power switch on (IG) and turn signal switch in LH position
    		11 to 14 V (60 to 120 times per minute)

    Text in Illustration 
    *a
    		Component with harness connected
    (Turn Signal Flasher Assembly)
    If the result is not as specified, the turn signal flasher assembly may have a malfunction.