INSTRUMENT PANEL SPEAKER > INSPECTION

for Preparation Click here



1. INSPECT FRONT NO. 2 SPEAKER ASSEMBLY

  1. With the speaker installed, check that there is no looseness or other abnormalities.

  1. Check that there is no foreign matter in the speaker, no tears on the speaker cone or other abnormalities.



    E222247E04

  1. Measure the resistance of the speaker.

    Standard Resistance:
    for 6 or 10 Speakers: 
    Tester Connection
    		Condition
    		Specified Condition
    1 - 2
    		Always
    		3.2 to 4.8 Ω
    for 13 Speakers: 
    Tester Connection
    		Condition
    		Specified Condition
    1 - 2
    		Always
    		4.6 to 7 Ω

    If the result is not as specified, replace the speaker.
    Text in Illustration 
    *a
    		Component without harness connected
    (Front No. 2 Speaker Assembly)



2. INSPECT FRONT NO. 4 SPEAKER ASSEMBLY

  1. With the speaker installed, check that there is no looseness or other abnormalities.

  1. Check that there is no foreign matter in the speaker, no tears on the speaker cone or other abnormalities.



    E222247E04

  1. Measure the resistance of the speaker.

    Standard Resistance:
    for 10 Speakers: 
    Tester Connection
    		Condition
    		Specified Condition
    1 - 2
    		Always
    		3.2 to 4.8 Ω
    for 13 Speakers: 
    Tester Connection
    		Condition
    		Specified Condition
    1 - 2
    		Always
    		4.6 to 7 Ω

    If the result is not as specified, replace the speaker.
    Text in Illustration 
    *a
    		Component without harness connected
    (Front No. 4 Speaker Assembly)