AIRBAG CUT-OFF SWITCH > INSPECTION

for Preparation Click here


NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Click here).



1. INSPECT AIRBAG CUT OFF SWITCH CYLINDER SUB-ASSEMBLY

  1. Turn the power switch off.

  1. Disconnect the cable from the negative (-) auxiliary battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



    C234623E02

  1. Disconnect the connector from the airbag cut off switch cylinder sub-assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    		Switch Condition
    		Specified Condition
    H134-2 (PMC+) - H134-1 (PMC-)
    		Cut off switch in ON
    		360 to 440 Ω
    H134-2 (PMC+) - H134-1 (PMC-)
    		Cut off switch in OFF
    		90 to 110 Ω

    Text in Illustration 
    *a
    		Component without harness connected
    (Airbag Cut Off Switch Cylinder Sub-assembly)
    If the result is not as specified, replace the airbag cut off switch cylinder sub-assembly.