WASHER NOZZLE (for Rear Side) > INSTALLATION

for Preparation Click here



1. INSTALL REAR WASHER NOZZLE

  1. Engage the 2 claws to install the rear washer nozzle.

  1. Connect the washer hose.



2. INSPECT REAR WASHER NOZZLE


  1. With the power switch on (READY), check that the center stream of washer fluid sprays on the windshield within the hatched area shown in the illustration.

    Standard:
    Washer fluid hits the windshield in the area shown in the illustration.



    E220053E01


    Standard Clearance 
    Area
    		Measurement
    A
    		22 mm (0.866 in.)
    B
    		6 mm (0.236 in.)
    C
    		72 mm (2.835 in.)
    D
    		108 mm (4.252 in.)



3. ADJUST REAR WASHER NOZZLE


    E220052

  1. Using a screwdriver, adjust the direction of the rear washer nozzle.

    NOTICE:
    Do not use a safety pin or other pointed tools. Doing so may damage the inside of the washer nozzle.

    HINT:
    Use a thin-bladed screwdriver with an approximately 1 mm (0.0394 in.) thick tip.



4. INSTALL REAR SPOILER SUB-ASSEMBLY
(Click here)