HYBRID TRANSAXLE SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT TRANSAXLE FLUID PRESSURE

NOTICE:
Perform the test at normal operating transaxle fluid temperature 50 to 80°C (122 to 176°F).

  1. Remove the rear engine under cover LH.

  1. Lift up the vehicle.

  1. Remove the fluid pump cover plug and O-ring.



    C209291

  1. Install an oil pressure gauge with the adapter.

  1. Put the engine in inspection mode (Click here).

  1. Measure the transaxle fluid pressure.

    Standard:
    Engine Speed
    		Transaxle Fluid Pressure
    1000 rpm
    		3 kPa (0.03 kgf/cm2, 0.4 psi) or more

    NOTICE:
    Be sure to cancel inspection mode immediately after the transaxle fluid pressure check is completed.



    C209292

  1. Install a new O-ring and fluid pump cover plug.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Install the rear engine under cover LH.