INPUT SHAFT OIL SEAL > REPLACEMENT

for Preparation Click here



1. REMOVE HYBRID VEHICLE TRANSAXLE ASSEMBLY
(Click here)


2. REMOVE INPUT SHAFT TYPE T OIL SEAL


    C209796E01

  1. Using a screwdriver with its tip taped, remove the oil seal.
    Text in Illustration 
    *1
    		Vinyl Tape

    NOTICE:
    When removing the oil seal, make sure not to damage the input shaft or hybrid vehicle transaxle housing.



3. INSTALL INPUT SHAFT TYPE T OIL SEAL


    C209797E01

  1. Coat the lip of a new oil seal with MP grease.

  1. Using SST and a hammer, tap in the oil seal.

    SST
    09330-50010  

    Oil seal installation depth:
    1.0 to 1.8 mm (0.0394 to 0.0709 in.)

    NOTICE:
    1. Ensure that no foreign matter adheres to the oil seal lip.
    2. Ensure that the oil seal is not at an angle.



4. INSTALL HYBRID VEHICLE TRANSAXLE ASSEMBLY
(Click here)